Q: Can this tighten strat style recessed nuts on the jack?

A: Yes, the black end is a ½” socket with a thin wall.

Q: Will this tool fit for tightening the nut on a Stratocaster style guitar jack?

A: Yes, the black end is a ½” socket with a thin wall.

Q: Will this strip?

A: If used for guitar care it should not but over time you may have some wear and tear. It is a really strong special plastic so make sure you use the correct size and that all six sides of the wrench is engaged on the the nut to avoid slipping and damage to the Octopus.

Q: Can I use this to take off and replace tuning machine bushings?

A: In most cases it is great for this, but if the hex nut on the bushing is extremely tight and does not budge then you may need a thicker metal wrench to remove them to avoid damaging the Octopus.

Q: Can I use this to tighten the nut on my strap locks?

A: It’s great for that if the nut matches the one of our sizes.